EZ Power & Light — Family Owned Since 2018

Electrical Panel Upgrade in Santa Ana, CA

100A to 200A service upgrades in Santa Ana — Federal Pacific and Zinsco replacement, permitted and owner-installed.

Electrical Panel Upgrade in Santa Ana, Orange County

EZ Power & Light upgrades electrical panels throughout Santa Ana, Orange County. Santa Ana homeowners and businesses call EZ Power & Light for honest electrical work. From historic Floral Park bungalows to downtown commercial, we bring years of SoCal experience.

A panel upgrade in Santa Ana is usually driven by one of three things: a dangerous obsolete panel (Federal Pacific or Zinsco), a panel that's simply full, or a new load — an EV charger, heat pump, or solar + battery — that the existing service can't carry. We see all three across Floral Park, Park Santiago, French Park and the rest of Santa Ana.

We quote flat-rate, never hourly. The owner walks your panel, runs the load calculation, and gives you a written number the same day — and that number is what you pay.

Why Santa Ana homes need panel upgrades

A lot of Santa Ana's housing stock predates the electrical demands of a modern home. Panels installed for a 1960s or 1970s household — a few lights, a stove, a TV — are now being asked to carry EV chargers, induction ranges, heat pumps, and home offices. When a panel is undersized or obsolete, breakers trip, bus bars overheat, and in the worst case it becomes a fire risk.

Federal Pacific and Zinsco panels are a specific concern. Independent testing has shown their breakers fail to trip reliably under overload — and many California insurers now refuse to renew homeowner policies until they're replaced. If you have one in Santa Ana, replacing it is both a safety upgrade and, increasingly, an insurance requirement.

Panel upgrade permits in Santa Ana

Every panel upgrade in Santa Ana is permitted and inspected. We pull the City of Santa Ana electrical permit under our C-10 license and coordinate the meter disconnect and reconnect with Southern California Edison.

We meet the inspector on site, restore power the same day, and label every breaker before we leave. We run the same process in nearby Anaheim and Orange.

Santa Ana neighborhoods we serve

Floral ParkPark SantiagoFrench ParkSouth Coast Metro

Common panel upgrade situations in Santa Ana

The specific electrical panel upgrade work Santa Ana homeowners and businesses call us for.

If you have
Floral Park Craftsman with knob-and-tube
We do

Phased rewire preserving historic character.

If you have
Downtown historic commercial TI
We do

Santa Ana Planning coordination for landmark spaces.

If you have
Older rentals needing code upgrades
We do

GFCI, AFCI, smoke/CO code package.

If you have
Adding an EV charger
We do

Upgrade to 200A with subfeed for the EV circuit.

If you have
Federal Pacific or Zinsco panel
We do

Replace immediately. Fire hazard.

How a Santa Ana panel upgrade job runs

Start to finish — the same process on every Santa Ana job, with the owner on site.

  1. 1

    On-site assessment

    30 minutes

    Owner walks your panel, runs load calc, photographs the existing service. Written quote same day.

  2. 2

    Permit + LADWP coordination

    3–10 days

    LADBS electrical permit pulled. Utility disconnect/reconnect scheduled.

  3. 3

    Panel swap day

    6–8 hours

    Meter pulled, new service entrance installed, new 200A panel wired and labeled.

  4. 4

    Final inspection

    3–5 business days

    LADBS inspector signs off. We meet them on site.

300+
Panels replaced
1 day
Typical turnaround
100%
First-inspection pass
Flat
Rate pricing

Electrical Panel Upgrade in Santa Ana — FAQs

Need electrical panel upgrade in Santa Ana?

Flat-rate quotes, permits handled, owner on every job. Call directly any time.

CallText