Electrical Panel Upgrade in Sherman Oaks, CA
100A to 200A service upgrades in Sherman Oaks — Federal Pacific and Zinsco replacement, permitted and owner-installed.
Electrical Panel Upgrade in Sherman Oaks, Los Angeles County
EZ Power & Light upgrades electrical panels throughout Sherman Oaks, Los Angeles County. Sherman Oaks homeowners and businesses call EZ Power & Light for reliable electrical service. From hillside properties needing EV charger installations to Ventura Boulevard commercial work, we handle every job personally.
A panel upgrade in Sherman Oaks is usually driven by one of three things: a dangerous obsolete panel (Federal Pacific or Zinsco), a panel that's simply full, or a new load — an EV charger, heat pump, or solar + battery — that the existing service can't carry. We see all three across Sherman Oaks Hills, Royal Woods, Valley Vista and the rest of Sherman Oaks.
We quote flat-rate, never hourly. The owner walks your panel, runs the load calculation, and gives you a written number the same day — and that number is what you pay.
Why Sherman Oaks homes need panel upgrades
A lot of Sherman Oaks's housing stock predates the electrical demands of a modern home. Panels installed for a 1960s or 1970s household — a few lights, a stove, a TV — are now being asked to carry EV chargers, induction ranges, heat pumps, and home offices. When a panel is undersized or obsolete, breakers trip, bus bars overheat, and in the worst case it becomes a fire risk.
Federal Pacific and Zinsco panels are a specific concern. Independent testing has shown their breakers fail to trip reliably under overload — and many California insurers now refuse to renew homeowner policies until they're replaced. If you have one in Sherman Oaks, replacing it is both a safety upgrade and, increasingly, an insurance requirement.
Panel upgrade permits in Sherman Oaks
Every panel upgrade in Sherman Oaks is permitted and inspected. We pull the LADBS electrical permit under our C-10 license and coordinate the meter disconnect and reconnect directly with LADWP.
We meet the inspector on site, restore power the same day, and label every breaker before we leave. We run the same process in nearby Encino and Studio City.
Sherman Oaks neighborhoods we serve
Common panel upgrade situations in Sherman Oaks
The specific electrical panel upgrade work Sherman Oaks homeowners and businesses call us for.
Emporia load-managed EV + subpanel.
LADBS plan check + after-hours work.
Neutral wires run, clean switch swaps.
Upgrade to 200A with subfeed for the EV circuit.
Replace immediately. Fire hazard.
How a Sherman Oaks panel upgrade job runs
Start to finish — the same process on every Sherman Oaks job, with the owner on site.
- 1
On-site assessment
30 minutesOwner walks your panel, runs load calc, photographs the existing service. Written quote same day.
- 2
Permit + LADWP coordination
3–10 daysLADBS electrical permit pulled. Utility disconnect/reconnect scheduled.
- 3
Panel swap day
6–8 hoursMeter pulled, new service entrance installed, new 200A panel wired and labeled.
- 4
Final inspection
3–5 business daysLADBS inspector signs off. We meet them on site.
What Sherman Oaks customers say
3 months ago
Old panel was full. New 200 amp service with room for the future EV charger. Owner was honest about what we needed and didn't upsell anything we didn't.
9 months ago
Fair pricing, professional work. The owner personally handled the utility coordination.
a year ago
Had 18 recessed lights installed throughout the house. Clean work, no damage to drywall, done in one day. The owner personally walked me through the dimmer options. Great experience.
a year ago
Solid install for our Rivian charger. Took a bit longer than quoted but the work is top notch. Would use again.
Electrical Panel Upgrade in Sherman Oaks — FAQs
Other electrical services in Sherman Oaks
Electrical Panel Upgrade in nearby cities
Need electrical panel upgrade in Sherman Oaks?
Flat-rate quotes, permits handled, owner on every job. Call directly any time.
